Symbols - Kobalt A011038 Manual Del Usuario

SYMBOLS

Some of the following symbols may be used on this product. Please study them and learn their
meaning. Proper interpretation of these symbols will allow you to operate the product better and
safer.
SYMBOLS
V Volts
A Amperes
Hz Hertz
~ Alternating Current
Class II Construction
RPM Rotating Speed
/min Per Minute
Ear Protection
Read The Operator's
Manual
Eye Protection
Safety Alert
The chain bar tip
Tip contact
Two hands
The power
Wet Conditions Alert
NAME
Voltage
Current
Frequency (cycles per second)
Type or a characteristic of current
Double-insulated construction
Revolutions per minute
Revolutions, strokes, surface speed, orbits, etc., per minute
Always wear ear protection.
To reduce the risk of injury, user must read and understand
operator's manual before using this product.
Always wear eye protection with side shields marked to
comply with ANSI Z87.1.
Precautions that involve your safety.
Contact of the chain bar tip with any object should be
avoided.
Tip contact can cause the chain bar to move suddenly
upward and backward, which can cause serious injury.
Always use two hands when operating the chain saw.
Always keep the power cable away from heat sources, oils
or sharp edges. Immediately remove plug from the mains if
the cable is damaged or entangled.
Do not expose to rain or use in damp locations.
DESIGNATION/EXPLANATION
4