Emerson RIPTIDE CF605BQ00 Manual Del Usuario página 13

3. Ceiling Fan Assembly
3.16
Route the Three Motor Wires through the Hanger Ball
(Figure 16).
Reinstall the Hanger Ball on the 8" Downrod as follows:
Position the Pin through the Two Holes in the
Downrod and align the Hanger Ball so the Pin is
captured in the Groove in the top of the Hanger Ball
(Figure 16).
Pull the Hanger Ball up tight against the Pin and
securely retighten the Phillips Head Set Screw in the
Hanger Ball (Figure 16).
A loose Phillips Head Set Screw could create fan
wobble.
3.17
The Fan comes with Black, Blue and White Wires that
are 80-inches long.
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball/Downrod
Assembly (Figure 17).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.
(Continued)
PIN
HANGER BALL
DOWNROD
Figure 16
INCHES
1/2
INCH
Figure 17
Please contact 1-800-654-3545 for further assistance
13
SET SCREW
BLACK WIRE
BLUE WIRE
6 TO 9 WHITE WIRE
HANGER
BALL
emersonfans.com
U.L. Model No.: CF605