(D) Measurement Time Setting (Test Timer) - KPS INSUTEST10000 Manual Del Usuario

10 KV INSULATION TESTER

(D) Measurement time setting (Test timer)

1. Turn on the insulation tester by rotating the function rotary switch to any
position (except OFF).
2. Press SELECT button to enter the minor function selection.
3. Press (value-add) " " or (value-reduce) " " to find the measurement time
setting, LCD display the following pictures respectively:
4. Press ENTER/SAVE, LCD displays the picture shown in below:
Press (value-add) " " or (value-reduce) " " to set the test Time (form 1 to 30
minutes).
After setting is complete, press ENTER/SAVE to confirm & save the data
measured.
Note
If Test Timer unit needs not to be adjusted, press ESC to skip it and return
back to the minor function selection.
7. Press ESC again to return back to the main page.
- 23 -
EN