(F)Clear/Erase The Data Stored (Log Clear) - KPS INSUTEST10000 Manual Del Usuario

10 KV INSULATION TESTER
(F) Clear/Erase the data stored (LOG Clear)
1. Turn on the insulation tester by rotating the function rotary switch to any
position (except OFF).
2. Press SELECT button to enter the minor function selection.
3. Press (value-add) " " or (value-reduce) " " to find the Erasing of data
stored, LCD display the following pictures respectively:
4. Press ENTER/SAVE to inquire whether to clear up the data or not; LCD
displays the picture shown in below:
Note
If the erasing unit needs not to be done, press ESC to skip it and return
back to the minor function selection.
5. Press ENTER/SAVE again to clear up the data; LCD displays the picture
shown in below:
Then return back to the minor function selection.
6. Press ESC to return back to the main page.
- 25 -
EN