Assembly And Adjustments - Stanley FATMAX SFMCG700 Traducido De Las Instrucciones Originales

ENGLISH
Fully Charged:
Green LED Solid
Hot/Cold Pack Delay:
Green LED Intermittent
Red LED Solid
Note: The compatible charger(s) will not charge a faulty
battery pack. The charger will indicate a faulty battery pack by
refusing to light.
Note: This could also mean a problem with a charger.
If the charger indicates a problem, take the charger and
battery pack to be tested at an authorized service centre.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indefinitely. The charger will keep the battery
pack fresh and fully charged.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or too cold,
it automatically starts a Hot/Cold Pack Delay, the green LED
(8a) will flash intermittently, while the red LED (8b) will remain
on continuously, suspending charging until the battery has
reached an appropriate temperature. The charger then
automatically switches to the pack charging mode. This
feature ensures maximum battery life.
Battery state of charge indicator (Fig. B)
The battery includes a state of charge indicator to quickly
determine the extent of battery life as shown in figure B. By
pressing the state of charge button (6a) you can easily view
the charge remaining in the battery as illustrated in figure B.
Installing and Removing the Battery Pack from the
tool
Warning! Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.
To install battery pack (Fig. C)
Insert battery pack (6) firmly into tool until an audible click
u
is heard as shown in figure C. Ensure battery pack is fully
seated and fully latched into position.
10
(Original instructions)
To remove battery pack (Fig. D)
Depress the battery release button (6b) as shown in figure
u
D and pull battery pack out of tool.
Storage hook (Optional extra) (Fig. E)
Warning! To reduce the risk of serious personal injury,
place the forward/reverse button in the lock-off position or
turn tool off and disconnect battery pack before making
any adjustments or removing/installing attachments or
accessories.
An accidental start-up can cause injury.
Warning! To reduce the risk of serious personal injury, ensure
the screw (10) holding the storage hook is secure.
Note: When attaching or replacing the storage hook (9),
use only the screw (10) that is provided. Be sure to securely
tighten the screw.
If the hook is not desired at all, it can be removed from the
tool.
To move the storage hook, remove the screw (10) that holds
the storage hook (9) in place.
Note: Various trackwall hooks and storage configurations are
available.
Please visit our website www.stanley.eu/3 for further
information.

Assembly and adjustments

Attaching the side handle
Warning! This handle SHOULD BE USED AT ALL TIMES to
maintain complete control of the tool. Always make sure the
handle is tight.
Screw the side handle (3) tightly into one of the threaded
mounting holes of the gear case.
WARNING: To reduce the risk of serious personal injury,
turn unit off and remove the battery pack before making
any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Fitting and removing the guard (Fig. F, G)
The tool is supplied with a guard intended for grinding
purposes and cutting purposes. Ensure you use the correct
guard specific for the intended operation. If the unit is intended
to perform cutting off operations, a guard (5a, Fig G) specific
for this operation must be fitted .
Fitting
Place the tool on a table, with the spindle (11) facing up.
u
Release the clamping lock (12) and hold the guard (5)
u
over the tool as shown.
Align the lugs (13) with the notches (14).
u