Topping Up The Oil; Connecting To A Compressed-Air Source - Parkside PDKS 6.3 B3 Traducción Del Manual De Instrucciones Original

Topping up the oil

To ensure that the compressed­air saw remains operational for as
long as possible, make sure that there is sufficient pneumatic oil in
the appliance .
The following options are available
♦ Attach a maintenance unit with an oiler to the compressor .
♦ Install a fitted oiler into the compressed­air line or the compressor .
♦ Add 3–5 drops of pneumatic oil into the connector nipple
every 15 minutes of operation .

Connecting to a compressed-air source

NOTE
► Before connecting the compressed­air source
–
the correct working pressure (3–6 .3 bar) must be fully
reached, and
–
you must ensure that the trigger is in its initial position .
♦ Attach the tool to a compressor by connecting the connector
nipple with the supply hose of the compressed­air source .
♦ The compressed­air source must be equipped with a pressure
reducer so that you can regulate the air pressure .
PDKS 6.3 B3 GB │ MT │ 69 ■