Verify The Network Connection Status - Yamaha R-N303 Manual De Instrucciones

Connecting to a network
7
Use the cursor keys (
security method and press RETURN.
Settings
None, WPA2-PSK (AES)
If you select "None", go to step 10 below.
Note
If you select "None", the connection may be insecure since the
communication is not encrypted.
8
Use the cursor keys (
"Security Key" and press ENTER.
KEY
9
Use the cursor keys to enter the security key
on this unit, and press RETURN to previous
state.
Enter either 8 to 63 character string or 64
hexadecimal digits.
Use the cursor keys ( / ) to select a character and
the cursor keys ( / ) to move the edit position.
You can insert / delete a character, by pressing
PRESET i (insert) or PRESET j (delete).
10
Use the cursor keys (
"Connect [ENT]" and press ENTER to save
the setting.
The SSID and security key information is required
for setup of a mobile device.
When you select the "SSID" in Step 5, you can
display the SSID configured for this unit.
11
Configure the Wi-Fi settings of a mobile
device.
For details on settings of your mobile device, refer to
the instruction manual of the mobile device.
(1) Enable the Wi-Fi function on the mobile device.
(2) Select the SSID of this unit from the list of
available access points.
(3) When you are prompted for a password, enter the
security key displayed in Step 9.
If the Wireless Direct connection cannot be made, the
security key may be incorrect. Configure the Wi-Fi
settings of a mobile device again. You can verify
whether the unit is connected to a wireless network
(p. 18).
12
To exit from the menu, press SETUP.
18
En
/ ) to select desired
/ ) to select
/ ) to select

Verify the network connection status

Perform the following procedure to verify the unit's
connection to a network.
Note
When using Wireless Direct, you will not be able to check the
status of the network connection.
CLEAR
Cursor keys /
ENTER
HOME
SETUP
SETUP
NOW PLAYING
1
Press SETUP.
2
Use the cursor keys (
"Network" and press ENTER.
Note
To return to the previous state, press RETURN.
3
Use the cursor keys (
"Information" and press ENTER.
4
Use the cursor keys (
"STATUS".
STATUS
¡Connect
When "Connect" appears, the unit is connected to a
network. If "Disconnect" appears, reset connection.
5
To exit from the menu, press SETUP.
MODE DISPLAY
ENTER
RETURN
RETURN
OPTION
VOLUME
MUTE
/ ) to select
/ ) to select
/ ) to select