Daikin DZ17VSA Instrucciones De Instalación página 19

SUBcoolinG = (SAT. liQUiD TEMP.) - (liQUiD linE
TEMP.)
charging Table
oD Ambient
< 65 °F
Temp (degf)
Subcooling Weigh in
(degf) Charge
Note: Subcooling information is valid only while the unit is operating at
100% capacity or 100% of compressor speed in CHARGE MODE.
Compressor speed is displayed under STATUS menu in the thermostat.
noTE: Not more than 3/8 lb. (6 oz.) of refrigerant be added
to the system at a time to achieve the target subcooling. It
is recommended adding 1 oz. refrigerant each time, then
wait 10 minutes to stabilize the system.
noTicE
c S
heck the chrader portS for leakS and tIghten ValVe coreS
. I
neceSSary nStall capS fInger
noTicE
d not
o adjuSt the charge BaSed on SuctIon preSSure
SATUrATED liQUiD
PrESSUrE TEMPErATUrE
cHArT
liQUiD
r-410A
PrESSUrE
°f
PSiG
200 70
210 73
220 76
225 78
235 80
245 83
255 85
265 88
275 90
285 92
295 95
305 97
65°F to 105°F > 105 °F
1.5 T - 10 ±1°F
2.0 T - 12 ±1°F
2.5 T - 14 ±1°F
Weigh in
3.0 T - 14 ±1°F
Charge
3.5 T - 10 ±1°F
4.0 T - 8 ±1°F
5.0 T - 9 ±1°F
- .
tIght
.
SATUrATED liQUiD
PrESSUrE TEMPErATUrE
cHArT
liQUiD
r-410A
PrESSUrE
°f
PSiG
325 101
355 108
375 112
405 118
415 119
425 121
435 123
445 125
475 130
500 134
525 138
550 142
h p
eat ump WIth
l
ockoutS
It is recommended to set the outdoor temperature lockouts
during the initial thermostat set up. Compressor lockout
temperature will enable the compressor to be turned off and
switch heating source from refrigeration to auxiliary/secondary
heating under low outdoor ambient conditions.
In case of 30 ft. or longer line set application, refrigerant may
be accumulated inside line set pipe. Select 15°F or higher
compressor (heat pump) lockout temperature to set heat
pump lockout.
Backup heat lockout temperature will enable auxiliary/sec-
ondary heating to be turned on when outdoor temperature
is much higher than indoor temperature, compressor might
stop operating under this circumstance.
,
If
19 19
o t
utdoor emperature