KTM Power Parts 60112035144 Manual Del Usuario página 7

7. Read the operating manual of the alarm system 601.12.035.000
Mounting up to model '08
1. First loosen the 5 retaining screws on the left and right and remove
1
2. Detach the retaining tab (2) with a screwdriver, tilt the entire
2
Mounting
3. Mount the LED (3) for the alarm system wiring harness.
a) Remove the cockpit.
3
b) Drill a hole with a 6.5 mm diameter in the cockpit.
c) Pull off the LED connector bushing and insert it in the cockpit.
d) Insert the LED through the connector bushing from behind until it
4
carefully and then check the function of the alarm system. Also check
the function of the REED switch. To do so, activate the alarm system,
unlock the quick release of the storage compartment and raise the
storage compartment cover.
Keep the hand-held transmitter ready to be able to switch the alarm off
at any time since the alarm siren sound reaches a volume of 114 dBA.
both side covers (1).
windshield including the headlight forward and pull the connector out
of the connector support.
engages.
e) Connect the LED connector to the vacant connector (4) in the main
wiring harness of the cockpit support.
f) Mount the cockpit, headlight and side covers.
7