Charging The Internal Battery - Schumacher Electric SLI2 Manual Del Usuario

LED INDICATOR
• Green LED solid – The internal battery
is charging.
• Green LED flashing – Charging has
aborted.
• Green LED pulsing – The internal
battery is fully charged.

7. CHARGING THE INTERNAL BATTERY

IMPORTANT! CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE
AND EVERY 3-6 MONTHS, TO KEEP THE
INTERNAL BATTERY FULLY CHARGED
AND PROLONG BATTERY LIFE.
7.1 To reduce the risk of electric shock,
unplug the unit's charger from the outlet
before attempting any maintenance or
cleaning. Simply turning off the controls
will not reduce this risk.
7.2 When charging the internal battery, work
in a well ventilated area and do not restrict
the ventilation in any way.
7.3 CHECKING THE LEVEL
OF THE INTERNAL BATTERY
To check the internal battery charge level,
make sure the unit is turned OFF,
then press the or
display will show the battery's percent of
charge. A fully charged internal battery will
read 100%. Charge the internal battery if the
display shows it is under 100%.
7.4 CHARGING THE INTERNAL BATTERY,
USING THE SUPPLIED AC CHARGER
WARNING! Use only the charger included
with the unit to charge the internal battery.
Using any other charger will damage
the unit.
1. Plug the AC charger into the unit's 12V
input socket (3 PIN connector).
2. Connect the charger to a 230 VAC
electrical wall outlet.
3. The red LED on the charger will
light, and the display will show
CHARGING-XX%. Complete charging
may take 6-8 hours.
button. The digital
• 5 •
FUNCTION BUTTONS
12V/USB/LANGUAGE –
Enables the 12V DC port and the
USB ports.
Press button for 5 seconds to select
the language on the display:
EN → DE → FR
JUMP START – Enables the jump
start function
4. When the internal battery is completely
charged, the green LED will pulse,
and the display will show FULLY
CHARGED.
5. When the battery is fully charged,
disconnect the charger from the AC
socket, and then unplug the charger
from the unit.
6. Charge the unit as soon as possible
after use.
7.5 CHARGING THE INTERNAL BATTERY
WHILE DRIVING
You may also charge the internal battery
while driving, using the 12V DC car
charger (included).
1. Make sure the car is running.
2. Plug the 12V DC adaptor cable into the
unit's 12V input socket.
3. Insert the other end of the accessory
cable into the vehicle's accessory
outlet (lighter socket).
4. The green LED will light, and the display
will show CHARGING-XX%. Complete
charging may take 6-8 hours.
5. When the internal battery is completely
charged, the green LED will pulse,
and the display will show FULLY
CHARGED.
6. When the battery is fully charged,
disconnect the accessory cable from
the unit, then from the lighter socket of
the vehicle.
7. Charge the unit as soon as possible
after use.
NOTE: Completely disconnect the charger
cable when the engine is not running.