General Warranty Conditions - Movement V3 Manual De Propietario

THIS WARRANTY IS VALID IF YOU AGREE TO THE CONDITIONS BELOW:
1. This warranty applies to MOVEMENT products only when:
1-1. The product is with the original buyer and with the original proof of purchase (Invoice
of purchase);
1-2. Has not been subject to: accidents, improper or negligent use, improper operation,
abuse, improper transport and storage, maintenance not in accordance with the specificati-
ons contained in the instruction manual, improper service, or modification not carried out by
Brudden;
1-3. The spare parts used are supplied by BRUDDEN;
1-4. Claims made within the warranty period.
2. This warranty does not cover damage or equipment failures caused by a failure in basic
and necessary maintenance as described in the manual.
THIS WARRANTY DOES NOT APPLY TO:
* Parts of natural wear and finishing items in general, including, but not limited to, the follo-
wing: fairings, adhesives, seat, supports or backrest of foam, rubber or plastic coverings;
* Products repaired or modified by third parties, without prior written authorization from
BRUDDEN;
* Service call for product installation or instruction to owners on how to use the product;
* Repairs made on products without the serial number or with the altered or damaged iden-
tification;
* Pick-up and delivery for repairs;
* No service charge incurred after the service warranty period.

GENERAL WARRANTY CONDITIONS

Expenses arising from any transportation or product freight to a Technical Assistance, trans-
portation or technical visit carried out by an authorized assistant, are borne by the buyer,
whether or not the product is covered by this guarantee.
The liability of this warranty is limited exclusively to the repair, modification or replacement of
the supplied product.
BRUDDEN is not responsible for damages to persons, third parties, other equipment and ins-
tallations, loss of profits or any consequential or consequential damages.
BRUDDEN reserves the right to stop the manufacture of its products without prior notice and
/ or modify the specifications and make improvements to the products at any time, without
incurring the obligation to carry out the same on products previously manufactured.