Intended Use - Würth 1952 004 635 Traducción Del Manual De Instrucciones De Servicio Original

DE
GB
INTRODUCTION
FR
It is compulsory to read this instruction manual before starting any
kind of action.
NL
The proper operation and full compliance of this product's
performance is guaranteed only if all the instructions provided in this
ES
manual are closely adhered to.
We guarantee that this product complies with the technical
IT
specifications described in this manual.
The manufacturer shall not be held responsible for any improper
uses other than those described herein.
PT
Use protective work gloves, protective footwear, hard hat and safety
goggles.
PL
Misuse:
DA
- This product should only be used as described in this
documentation; any other use is considered improper.
EL
- The manufacturer accepts no responsibility for any
damage caused by the incorrect or unreasonable use of
the equipment.
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.

INTENDED USE

The tool set described in this manual is used to make clean holes
in plastic bumpers without burrs. This is necessary when the
replacement bumper supplied by the manufacturer does not have
the holes for mounting the parking sensors.
According to some manufacturers' repair instructions, holes should
be drilled only after painting to guarantee, once repaired, an
appearance as close to the original as possible.
Furthermore, the centering pins contained in the tool set ensure the
correct fixing and alignment of the sensor supports during fastening
(welding/gluing).
METHOD OF PREPARATION
1
2
3
4
11