RIDGID OL50135AL Manual Del Operador página 17

TROUBLE
Thermal overload 1. Low voltage
protector cuts out 2. Clogged air filter
repeatedly
3. Lack of proper ventila-
4. Unit is plugged into
5. Low oil level
1. Loose connections (fit-
Air tank pressure
drops when com-
pressor shuts off
2. Loose drain valve
3. Check valve leaking
Excessive moisture 1. Excessive water in air
in discharge air
2. High humidity
Compressor runs 1. Defective pressure
continuously
2. Excessive air usage
Compressor vibrates Loose mounting bolts
Air output lower than 1. Broken inlet valves
normal
2. Intake filter dirty
3. Connections leaking
PROBABLE CAUSE
tion/room temperature
too high
extension cord
tings, tubing, etc.)
tank
switch
17
REMEDY
1. Check with voltmeter
2. Clean filter (see
Maintenance section)
3. Move compressor to well
ventilated area
4. Remove extension cord
5. Add oil to proper level
1. Check all connections with
soap and water solution
and tighten
2. Tighten
3. Disassemble check valve
assembly, clean or replace
DANGER:
!
Do not disassemble
check valve with air in
tank; bleed tank
1. Drain tank
2. Move to area of less
humidity; use air line filter
1. Replace switch
2. Decrease air usage; com-
pressor not large enough
for a requirement
Tighten
1. Have authorized service
representative repair unit
2. Clean or replace intake fil-
ter
3. Tighten connections