Kickback And Related Warnings - Flex SE 14-2 125 Instrucciones De Funcionamiento

SE 14-2 125/SE 14-2 150
 Regularly clean the power tool's air vents.
The motor's fan will draw the dust inside
the housing and excessive accumulation
of powdered metal may cause electrical
hazards.
 Do not operate the power tool near
flammable materials.
Sparks could ignite these materials.
 Do not use accessories that require liquid
coolants.
Using water or other liquid coolants may result
reesult in electrocution or shock.
Special safety instructions
for sanding:
 Use only those sanding tools authorised
for use with your electric power tool and
the guard designated for this sanding
tool.
Sanding tools, which are not designated
for use with the electric power tool, cannot
be adequately shielded and are unsafe.
 The guard must be attached securely
to the electric power tool and adjusted
to ensure maximum safety, i.e. the smal-
lest possible part of the sanding tool
is exposed to the operator.
The guard should protect the operator from
fragments and accidental contact with the
sanding tool.
 Sanding tools may be used for the
recommended applications only.
For example: Never sand with the side
area of a diamond sanding pad.
Diamond sanding pads are designed
to remove material with the underside
of the sanding pad. If a lateral force is applied
to these sanding tools, they may shatter.
 Always use undamaged clamping
flanges in the correct size and shape
for the insertion tool you have selected.
Suitable flanges support the insertion tools
and therefore reduce the risk of a break.
 Do not use worn insertion tools from
larger electric power tools.
Insertion tools for larger electric power tools
are not designed for the higher speeds
of smaller electric power tools and may break.
Special safety instructions
for sanding:
 Do not use oversized sanding sheets, but
follow the manufacturer's specifications
for the size of sanding sheets.
Sanding sheets which project over
the sanding pad may cause injuries
as well as block and rip the sanding
sheets or cause a kickback.
Special safety instructions
for polishing:
 Do not allow any loose portion
of the polishing bonnet or its attach-
ment strings to spin freely.
Tuck away or trim any loose attach-
ment strings.
Loose and spinning attachment strings
can entangle your fingers or snag on the
workpiece.

Kickback and Related Warnings:

Kickback is the sudden reaction to a pinched
or snagged rotating insertion tool, such
as a sanding disc, sanding pad, wire brush,
etc. Pinching or snagging may cause a rotating
insertion tool to stop abruptly.
For example, if an abrasive wheel is snagged
or pinched by the workpiece, the edge of the
wheel that is entering into the pinch point can
dig into the surface of the material causing the
wheel to climb out or kick out.
The wheel may either jump toward or away
from the operator, depending on direction
of the wheel's movement at the point of pin-
ching. Abrasive wheels may also break under
these conditions.
For example, if a sanding disc is snagged
or pinched by the workpiece, the edge of the
sanding disc which is entering the workpiece
may become caught and cause the sanding
disc to break off or kick back.
The sanding disc then moves towards or away
from the operator, depending on the direction
in which the disc is rotating at the point
of pinching. Sanding discs may also break
under these conditions.
A recoil occurs if the electric power tool is used
incorrectly or improperly.
A recoil can be prevented by appropriate
precautions as described below.
17