Comet MTP MC 8 Instrucciones Para El Ensamblaje -Uso Y Mantenimiento página 29

CAUTION
• In the case of electric motor pumps with three-phase motor, be very careful to make sure the motor
rotation direction corresponds to that indicated on the reduction gear. If this is not the case, contact a
Skilled Technician, who will simply switch over a lead inside the power plug. Failure to comply with this
instruction will seriously damage the motor pump.
PRECAUTIONS CONCERNING PUMPED CHEMICAL PRODUCTS
WARNING
• Also follow the instructions contained in the manual of the machine in which the motor pump is
integrated.
• Store the chemical products in ventilated premises, with door equipped with lock. The products must be out of
reach of children and unauthorised persons. Place hazard notices outside the premises.
• Carefully read the safety instructions and precautions on the chemical product packs, so as to be able to take
suitable measures to prevent hazards affecting people and the environment. In particular, do not exceed
maximum recommended concentrations and only prepare the quantity of product needed to avoid dispersion
on the ground and in the water system.
• In case of contact with eyes, immediately rinse with water. In case of swallowing, do not induce vomit: immediately
contact a doctor, and show him/her the pack of detergent. Avoid inhaling any gases produced.
• Always wear adequate protection gear and keep away children, unauthorised persons and personnel not
adequately protected. Do not drink, eat and smoke.
• At the end of the various operations, carefully wash your hands and face.
• Carefully wash any clothes that have come into contact with the chemical products. Any contaminated items
must be immediately washed.
• The chemical product containers must be disposed of through pre-sorted waste collection centres and in
accordance with the laws of the country where the machine in which the motor pump is integrated is operating.
• During operation, avoid the chemical products reaching buildings, homes, public and private lands, gardens,
roads, public and private water courses and places frequented by people and animals. Irrigation treatments
near the above places must be performed in the absence of wind.
CHECKING AND CONNECTING UP TO WATER MAINS
WARNING
• Also follow the instructions contained in the manual of the machine in which the motor pump is
integrated.
• Follow the water mains connection instructions applicable in the country where the machine in which the motor
pump is integrated is installed.
CAUTION
• Follow the water mains connection instructions shown in the
with special reference to the priming depth and supply pressure and temperature: in case of any doubts,
contact a Skilled Technician.
• The suction of motor pump must always be equipped with a suitably-sized filter: frequently make sure this
is clean.
• Never operate the motor pump:
- without water supply;
- with salt water or water containing impurities: if this occurs, have it operate for a few minutes with clean
water.
"S
PECIFICATIONS AND TECHNICAL DATA
EN
" paragraph,
29