Explication Of Warning Symbols; Safety Instructions - IKA C 6000 Serie Instrucciones De Seguridad


DANGER indicates an imminently hazardous situation, which, if not avoided, will result in death, seri-
DANGER
ous injury.
WARNING indicates a potentially hazardous situation, which, if not avoided, can result in death, seri-
WARNING
ous injury.
CAUTION indicates a potentially hazardous situation, which, if not avoided, can result in injury.
CAUTION
NOTICE indicates practices which, if not avoided, can result in equipment damage.
NOTICE
• Read the operating instructions completely before
starting up and follow the safety instructions.
• Keep the operating instructions in a place where it can be
accessed by everyone.
• Ensure that only trained staff work with the device.
• Follow the safety instructions, guidelines, occupational
health, safety and accident prevention regulations.
• Set up the equipment in a spacious area on an even, sta-
ble, clean, non-slip, dry and fireproof surface.
• Do not operate the equipment in explosive atmospheres,
with hazardous substances.
• Protect the equipment and accessories from bumping and
impacting.
• Check the equipment and accessories for damage before
each use. Do not use damaged components.
• Safe operation is only guaranteed with the accessories
described in the "Accessories" section.
• The socket for the mains cord must be easily accessible.
• Socket must be earthed (protective ground contact).
• The voltage stated on the type plate must correspond to
the mains voltage.
• The equipment can only be disconnected from the mains
supply by pulling out the mains plug or the connector plug.
• Disconnect the mains plug before attaching or changing
any accessories.
This "Safety instructions" includes only the most important informa-
tion! It does not replace "Operating instructions".
i
Please read "Operating instructions" carefully!

Explication of warning symbols

Safety instructions

• Disconnect the mains plug before cleaning, maintenance
and transportation of the unit.
• The equipment must only be opened by trained special-
ists, even during repair. The equipment must be unplugged
from the power supply before opening. Live parts inside
the equipment may still be live for some time after unplug-
ging from the power supply.
• Coverings or parts that can be removed from the device
without the aid of any tools must be put back on the device
again to ensure safe operation, for example to keep foreign
objects and liquids, etc. from getting into the device.
• The IKA ® calorimeter system
dards/isoperibol calorimeter system can be used only for
determination of the calorific values of solid and liquid
substances to national and international standards (such
as DIN 51900, BS 1016 T5, ISO 1928, ASTM 5468,
ASTM 5865 and ASTM 4809).
C 6000 global standards/isoperibol:
DANGER
The maximum extra energy added to
the decomposition vessel must not exceed 40,000 J (se-
lect the test mass accordingly). The permitted operating
pressure of 230 bar (23 MPa) must not be exceeded.
The maximum permitted operating temperature must not
exceed 50 °C.
EN
C 6000 global stan-
C1/
5