Sagola DOBLE 250 Manual De Instrucciones página 28

Set the washing timer by turning it clockwise to the
desired time. The solvent aspirated from the recircu-
lation solvent tank will begin to come out of the
dispenser nozzles and the spray gun nozzle of the
spray jet nozzle system inside the tub to perform
further washing of the parts, while the blower nozzles
will deliver air.
If the lid of the tub is opened during the wash
cycle, the pump stops, stopping the wash
cycle. In any case it is strictly forbidden to
open the lid of the tub during washing to
prevent any spurts of detergent coming out
of the tub on account of the residual pressu-
re inside the tubes.
Once the wash time set has elapsed the pump stops
and the vapour suction begins.
Final automatic rinse
Position the dirty-clean lever in the rinse position
(horizontal) for clean solvent and press the rinse
button for the desired time for this operation. This
way the dispenser nozzles of the washing spray jet
system will spray clean solvent into the tub and the
blower nozzles will deliver air.
Rinsing of the pieces in the tub terminates when the
rinse button is released and aspiration works.
ATTENTION!
Press the rinse button only for the few
seconds needed for this operation to avoid
wasting clean solvent.
The clean solvent used to rinse the pieces is drained
off into the drum of already used solvent.
Open the lid of the tub and remove the parts of the
gun from the various supports. When performing
these operations, the air suction will work.
Blow some air on the spare parts to dry them by
means of the air blow gun, if necessary.
Once the washing operations have been completed,
close the lid of the tub level and the lid of the machi-
ne.
Always check the position of the dirty-clean lever,
before performing the initial wash of the spray guns:
it must be vertical for recirculation solvent, so as not
to waste clean solvent. If you want to blow air on the
gun parts to dry, use the special dispenser air gun.
After finishing the washing operation close the lid of
the tank and switch OFF general ON / OFF valve to
stop the intake of the fumes.
Manual cleaning with brush
Put the ON/OFF switch in the ON position to dispen-
se recycled solvent trough the brush.
Manual rinsing with atomized use of solvent
On the suction hood, a nozzle is present for nebuli-
zed from which protrudes a small amount of clean
solvent in spray form.
Turn ON the ON/OFF valve general, turn On the
valve ON/OFF of the atomized if you want a manual
rinsing of the pieces or to take clean solvent.
Keep the lid of the tank opened not to disperse the
solvent.
The solvent used to clean the spray will fall within the
dirty solvent drum through the discharge place on the
washing tub.
8.3. ASPIRATION SYSTEM
The machine has an
aspiration system. The
system benefits from the
Venturi effect generated
by a high-speed
atomizing nozzle
aspirates and conveys
the fumes towards the
outside of the hood.
The aspiration in both hoods starts up automatically
when the machine is turned on with the ON/OFF
valve on the control pad.
- 29 -
air
that