Troubleshooting - HoMedics Walgreens BPW-410WGN Manual Del Usuario

vision reception, which can be determined by turning the
product on and off, the user is encouraged to try to cor-
rect the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and
the receiver.
• Consult the dealer or an experienced radio/TV techni-
cian for help.
For Canada only
This digital apparatus does not exceed the Class B limits
for radio noise emissions from digital apparatus as set
out in the interference-causing equipment standard enti-
tled "Digital Apparatus", ICES-003 of the Canadian
Department of Communications.
Cet appareil numérique respecte les limites de bruits
radioeléctriques applicables aux appareils numériques de
Classe B prescrites dans la norme sur le matériel brouilleur:
"Appareils Numériques", ICES-003 édictée par le ministre
des communications.
31

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
POSSIBLE
SYMPTOMS
CAUSES
Unit does not turn Batteries have
on when the run down.
START/STOP
button is pushed.
Battery polarities
have been posi-
tioned incorrectly.
EE measurement Cuff has been
error symbol shown placed incorrectly.
on display or the
blood pressure
Did you talk or
value is displayed
move during
excessively low
measurement?
(or high).
Shaking of the wrist
with the cuff on.
E1 error symbol Air circuit
shown on display abnormality.
E2 error symbol Inflation pressure
shown on display exceeding 300 mmHg.
E3 error symbol Data error.
shown on display
– – appears on
Recalibration alert.
display
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassem-
ble or attempt to repair the unit by yourself. Contact infor-
mation for HoMedics Consumer Relations Department can
be found on the warranty page (See page 34).
CORRECTION
Replace them
with two new AAA
alkaline batteries.
Re-insert the
batteries in the
correct positions.
Wrap the cuff prop-
erly so that it is
positioned correctly.
Measure again.
Keep wrist
steady during
measurement.
Measure again.
Switch the unit off,
then measure again.
Remove and reload
the batteries.
Refer to page 27 for
more information.
32