Troubleshooting - HoMedics BPW-715 Manual Del Usuario

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
SYMPTOMS
Unit does not
turn on when the
"START/STOP"
button is pushed.
EE measurement
error symbol shown
on display or the
blood pressure
value is displayed
excessively low
(or high).
E1 error symbol
shown on display.
E2 error symbol
shown on display.
E3 error symbol
shown on display.
EP error symbol
shown on display.
NOTE:
If the unit still does not work, contact HoMedics Consumer Relations.
Under no circumstance should you disassemble or attempt to repair
the unit by yourself. Contact HoMedics Consumer Relations at
the number listed in the Warranty section.
POSSIBLE
CAUSES
Batteries have
run down.
Battery polarities
have been positioned
incorrectly.
Cuff has been placed
incorrectly.
Did you talk or
move during
measurement?
Shaking of the wrist
with the cuff on.
Air circuit
abnormality.
Inflation pressure
exceeding 300 mmHg.
Error determining
measurement data.
System error.
28
CORRECTION
Replace them with
2 new "AAA" alkaline
batteries.
Reinsert the batteries in
the correct positions.
Wrap the cuff properly
so that it is positioned
correctly. Measure again.
Keep wrist steady
during measurement.
Measure again.
Measure again.
Switch the unit off, then
measure again.
Rewrap the cuff properly
so that it is positioned
correctly. Take new
measurement.
System Error: Turn off
monitor and measure
again. If EP error still
appears on the display,
please call a Consumer
Relations representative.