BH FITNESS G2334N Manual Del Usuario página 6

FITTING THE BATTERIES.
This monitor uses two 1.5 volt AAA
ALKALINE BATTERIES. To fit the
batteries, remove the rear cover on
the monitor, Fig.1, and carefully insert
the two "AAA" type batteries into the
battery compartment (A) making sure
that the battery's polarity is correct
(matching the battery's «+» terminal
with the «+» sign inside the battery
compartment, and the «-» terminal
with the «-» sign).
Close the cover, as shown in Fig.1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Discarded batteries must
be deposited in special containers,
Fig.2.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs
distance, exercise time, calories burnt
and pulse rate.
You can change the display by
pressing UP
the machine stopped.
Pressing the ENTER key for more than
3 seconds will reset all of the values.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
of
or DOWN keys with
English
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
A.TIME FUNCTION.-
This function counts up or down in
steps
maximum of 99:00 minutes.
1. Press any key to switch the monitor
on.
2. Press the ENTER key to start the
small TIME window flashing.
3. Press the UP
select the time and ENTER to confirm.
4. Begin the exercise and the time
value will begin the countdown, when
it reaches zero it will beep for 10
seconds,
selected time has elapsed, the time
value will then start counting upward.
B.DISTANCE FUNCTION.-
This function counts up or down in
steps of 0.1 km/ml, up to a maximum of
999 km/ml.
1. Press any key to switch the monitor
on.
2. Press the ENTER key to start the
DIST (DISTANCE) window flashing.
3. Press the UP
select the distance.
speed,
4. Begin the exercise and the distance
value will begin the countdown, when it
reaches zero it will beep for 10
seconds, advising you that the selected
distance
distance value will then start counting
upward.
6
of one second,
or DOWN
advising you
or DOWN
has been
up to a
keys to
that the
keys to
covered, the