UFESA PA7000 Manual De Instrucciones página 27

1
Empty the jug.
2
Clean the jug (see section "Cleaning and
maintenance of appliance with installed mixing cup
(liquidizer) / grinder"). Turn the jug upside down and
place it on a flat and stable surface.
3
Hold the jug with one hand and the other hand
use to unscrew the blade set in a counter-clockwise
direction.
4
Carefully remove the blade set together with gasket.
Blades used in appliance are sharp.
Handle with care.
Installation of cutting set
1
Insert the gasket into the pit in the blade set.
2
Remove the cover from a jug of the blender. Turn
the jug upside down and place it on a flat and stable
surface.
3
Put the blade set into the hole in the bottom of the jug.
4
Hold the jug with one hand while the other one use
to spin blade set clockwise until it stops.
GRINDER
Characteristics of the appliance
Grinder is designed for crushing and grinding
components, such as pepper, coffee beans, rice,
wheat, sesame seeds, nuts (shelled), etc., as well as for
chopping meat.
Grinder is not suitable for grinding very
hard ingredients such as ice cubes, and
nutmeg.
Never use a grinder to grind the sugar,
as this may damage the appliance.
Before proceeding to chop, peel the meat
from the veins, mucous and fat and then
cut into pieces of approximately 2x2 cm.
Maintenance and operation
● Put the ingredients into a container of grinder.
Do not exceed the maximum level of
content, as it is marked on the grinder
container.
1
Put and tighten the basis of grinder with a set of
blades grinder on the thread of the container of grinder.
2
Turn the grinder upside down and place it on the
base for accessories.
3
Block the grinder by turning it clockwise until
G
it locks (the characteristic "click" indicates that the
grinder is correctly installed).
● Run the appliance by turning the control knob to the
desired position. Adjust the speed according to mixed
components.
We recommend using the "PULSE"
program, or maximum speed.
Grinding of different products that are
grouped together without a thorough
washing may result in penetration of
smell and taste of the product previously ground.
Do not use the appliance with installed
grinder in continuous operation for more
than 30 seconds. If within 30 seconds
failed to complete the process of grinding, turn
off the appliance and wait 5 minutes before
restarting.
4
After the grinding set the control knob to "0".
Always immediately after use wash the
container of grinder and grinder base
with a set of blades with hot water plus
dishwashing liquid. Wipe the grinder seal with
a damp cloth.
H