After Each Use - UFESA PA7000 Manual De Instrucciones

1
Press the locking clamps all the way down to
release the lid.
2
Remove the pusher and the lid.
3
Slide out the pulp container.
4
Remove the juice bowl with the strainer by turning
the bowl counter-clockwise so that the symbol
the bowl is aligned with the symbol
unit. Remove the juice bowl from the motor unit.
Wash all parts (except the motor unit)
carefully in warm water with some
washing liquid. You can also clean them
in a dishwasher at max. 60°C (except the juice
bowl, strainer and motor unit). Dry all parts
thoroughly and replace once dry.
Assembling
1
Place the juice bowl on the motor unit, aligning
the symbol on the underside of the bowl with the
symbol on the motor unit.
2
Lock the juice bowl by turning it clockwise so that
the symbol on the motor unit is aligned with the
symbol on the underside of the bowl.
3
Mount the strainer on the skimmer so that the notch
on the skimmer is aligned with the groove in the strainer.
The strainer may be mounted in one
position only.
4
Slide the pulp container under the lid as follows:
lean the pulp container and place it under the insert of
the bowl so that the protrusion in the pulp container
is placed inside the groove in the bowl. Then slide it in
towards the motor unit.
5
Install the lid so that the protrusion of the lid is in
the notch of the juice bowl.
6
Lift up both clamps and clamp them onto the
fasteners located on the lid.
7
Press the clamps to the juice bowl (a characteristic
click indicates that they are clamped correctly).
8
Put the juice collector so that the juice spout is
inside the collector.
If you fail to assemble the locking
clamps correctly, a safety device will
prevent the switch-on of the appliance.
Prepare washed fruit and vegetables and
place them near the appliance.
Juice extractor start up and operation
on
on the motor
● Make sure control knob is set to position "0".
● Insert the plug into the wall outlet and run the juice
extractor turning the control knob as required to speed
1 or 2 (see the table "Recommended centrifugation
speeds for selected fruits and vegetables").
● Put the fruit or vegetables into the hopper of the
cover and lightly press them with pusher.
Do not push products with your fingers
or other objects.
C
● Transfer the extracted juice from the container into
glasses, cups, etc.
The jug has a lid with a froth separator
to stop coarse juice particles and froth.
● If necessary (if excessive pulp deposited on the
strainer causes vibrations) use the "PULSE" function.
PULSE function
The "PULSE" function allows to remove excessive
pulp on the strainer. Turn and hold the control knob to
"PULSE" to operate the appliance at maximum speed.
Release the knob to stop the appliance.

After each use

● Turn the control knob to "0" to switch off the
appliance.
● Unplug the appliance.
● Once the motor unit stops, disassemble the appliance
to wash all parts (see "Disassembling").
● Remove all pulp from the pulp container.
Do not allow the overflow of the tank for
leftovers. When you pull it out,
accumulated surplus of leftovers may
fall from the tank when tilting.