Motor/Tube Assembly; Wiring - SOMFY Sonesse Ultra 50 RS485 Manual

EN

2.1.3. Motor/tube assembly

1) Slide the motor into the roller tube.
2) The motor wheel must be locked in place to prevent
movement inside the roller tube:
• This can be done either by xing the roller tube to the
motor wheel using 4 x Ø 5 mm self-tapping screws,
or by using 4 x Ø 4.8 mm steel pop rivets placed
5 mm to 15 mm from the outer edge of the motor
wheel, regardless of the roller tube.
The screws or pop rivets must only be attached to the
motor wheel and not to the motor.
3) Slide the end cap into the roller tube and ensure that the
assembly is solid.
2.1.4. Installing the motor/tube assembly
The motorised product must not be compressed between the brackets.
1) Install and x the motor/tube assembly onto the end
bracket f and onto the motor bracket g:
Ensure that the motor/tube assembly is secured onto
the end bracket. This operation prevents the motor/
tube assembly from coming out of the end bracket
mounting when the roller blind reaches the lower end
limit position.
2) For star head motors, ensure the stop ring h in place.

2.2. WIRING

Cables which pass through a metal wall must be protected and isolated using a grommet
or sleeve.
Attach cables to prevent any contact with moving parts.
The cable on the Sonesse Ultra 50 can be removed. If it is damaged, replace it with an
identical cable.
Leave the motor power supply cable accessible: it must be possible to replace it easily.
Switch off the power supply.
-
Connect the motor according to the information in the table below:
-
Neutral (N)
120V 60 Hz
100V 50/60 Hz
230V 50 Hz
220V 60 Hz
Neutral (N)
120V -60 Hz
52
Live (L)
White Black
Blue Brown
US PIGTAIL CONNECTOR
Live (L)
White Black
Copyright © 2015 - 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1)
2)
3)
1)
g
2)
h
Earth ( )
Green
Yellow/Green
Earth ( )
Green
Sonesse Ultra 50 RS485
15 mm
5 mm
L1
20 mm
f
L1L2N
N
L2
L1