Operation; Temporary Screens 1 (15 Seconds) - Nice MG3000 Manual Completo

Another example of installation is shown below, where the two
CAN connections of the MG3000 are used.
PLACE INTERNAL
"END OF LINE"
JUMPER
This other example shows a situation where we have more than one MG3000
on the same CAN network.
CAN 1 HIGH
CAN 1 LOW
CAN 2 HIGH
CAN 2 LOW
In cases where there is more than one IP Module, it is possible to connect more
than one MG3000 on the same CAN network.
NOTE: For this application, read also [12].

07. OPERATION

After properly installed and connected to the receivers of the access devices, the
information on the activation of the door from one of the receivers will be shown
on the display, alternately indicating two screens for 15 seconds.

07.1 TEMPORARY SCREENS 1 (15 seconds)

In the temporary screens some identification information is presented, such as:
- number of the user's apartment and building;
- according to the event, it may indicate panic, low battery or cloning;
- pre-programmed labels with function assigned to the receiver with an address
from 1 to 8 and their respective relay output;
- username up to 18 characters long.
Up to 500 meters
Figure 6.b
Up to 500 meters
Figure 6.c
- ENGLISH -
216
Up to 500 meters
CAN 1 HIGH
CAN 1 LOW
CAN 2 HIGH
CAN 2 LOW
PLACE INTERNAL
"END OF LINE"
JUMPER
PLACE INTERNAL
"END OF LINE"
JUMPER
13