Basic Programming; Add User; Binding The Serial/Device Id To The System; Remote Control - Nice MG3000 Manual Completo

10. BASIC PROGRAMMING

10.1 ADD USER

To save a device to the system, first tap "Add user" on the "Basic Menu" screen.
Select the device type (Control, Active Tag, Card, Password, Biometrics or Pas-
sive Tag), and then follow the steps according to the chosen item.

10.2 BINDING THE SERIAL/DEVICE ID TO THE SYSTEM

10.2.1 REMOTE CONTROL

The capture of the remote-control serial can be done from the QUICK REGIS-
TRATION screen or the ADD USER - REMOTE CONTROL screen.
Press the B1+B2 buttons on the control simultaneously, twice, within an interval
of less than 3 seconds or until the screen advances to the screen with the fields
for filling in the user data. After this procedure, proceed with the registration
according to the instructions in 10.2.7.
- ENGLISH -
222
Figure 9.1.f
Figure 10.1.a
19