Nice MG3000 Manual Completo página 248

Figure 11.1.e
It is still possible that a receiver does not respond to the transfer verification, ei-
ther by default or if it has been enabled in the registration process, but is not
connected to the network. In these cases, the message "NO RESPONSE" is
displayed indicating a possible error in the equipment or in the activation during
the registration of an equipment that is not installed.
Figure 11.1.f
The communication failure error can be presented in cases of wiring failure or
poor baud rate configuration between the equipment.
Figure 11.1.g
- ENGLISH -
45
248