Nice MG3000 Manual Completo página 241

If the fingerprint has already been registered, go back to the menu under the op-
tion "EDIT USER" to signal that the biometrics registered belongs to a doorman.
Figure 10.6.f
Follow the editing step by step as described previously in the item 10.2.7 option.
The last parameter displayed, following the registration screens, becomes the
device identification as being a concierge or not [figure 10.6.f]. If, after the con-
tinuous beep sounds, the "RESET" button is not pressed or the fingerprint is not
validated, after the time programmed in the "RELAY TIME" option, a new event
will be generated: "WAKE UP DOORMAN NOT ANSWERED", in addition to a
signal from the MG3000 for TERMINAL BLOCK MODULE (optional accessory)
which in turn will change the state of the internal relay. This time is configured in
the "WAKE UP DOORMAN 2/2" screen in the advanced menu.
Figure 10.6.g
The "RELAY RESET TIME" option corresponds to the interval in which the digi-
tal signaling will remain active on the MG3000 through the TERMINAL BLOCK
MODULE, after the occurrence of an "WAKE UP DOORMAN NOT ANSWERED"
event. After the relay reset time has passed, the MG3000 sends the command to
turn off the TERMINAL BLOCK MODULE relay.
- ENGLISH -
38
241