Storage And Care; Control Unit; Troubleshooting Guide - Sunrise Medical Jay Dermafloat LAL 1000 Serie Manual Y Garantía De Instrucción Del Utilizador

Control Unit:

Before use check the power cord and plug for abrasions or
excessive wear. Plug in the unit and verify air flows from the unit
hose connection port. The power cord may be wrapped around the
unit for convenience.
resistance, then store the unit in an area that is appropriate for an
electronic medical device.
Homecare Low Air Loss Mattress:
Gently fold over the deflated air mattress in half or thirds (head and
foot section toward the middle) for temporary storage.
Standard Low Air Loss Mattress:
Before use check the air manifold for kinks or breaks. Replace if
necessary. Coil the hose loosely and roll the deflated mattress
starting at the head end.
containment. Place in a plastic bag for temporary storage.

TROUBLESHOOTING GUIDE

Problem:
Solution:
Problem:
Solution:
For Technical Support call 1-800-685-5600.

STORAGE AND CARE

Loss of power.
Make certain the power receptacle has power, and the
power ON/OFF switch is in the illuminated "ON" position.
Periodic testing will verify proper system operation.
Inflation pressures lower than specified can result in poor
or reduced patient support.
Mattress does not inflate or is too soft.
Make certain the air hose is not kinked, cracked, or split.
Verify the power switch is illuminated, signifying the
master control unit has power.
connect is fully inserted. Verify that all 20 air cushions are
connected to the air manifold. Inspect and/or clean intake
air filter.
Wrap the unit in a plastic bag for dust
Use the base mounted straps for
15
Verify the hose quick