Falltech C7372 Manual De Uso E Instrucciones página 8

5.8 Choke-On Sling Anchor Installation: Ensure that the rated structural member is free of sharp, jagged, or abrasive edges.
1. Place the Choke-On Sling Anchor over the top of the structural member with web loop is hanging on one side and the D-ring hanging
on the other. Pass the D-ring or O-ring through the web loop, see Figure 11 and cinch the Choke-On Anchor down tight, see
Figure 12.
2. Ensure ensure that the Choke-On Sling Anchor cannot come off of the structural member at any point along the intended path of
movement or at joints or ends.
3. If the structural member that this Choke-On Sling Anchor is attached to is sloped or vertical, the anchor must be positioned next
to a stop which will prevent it from sliding or moving in the event of a fall. The load direction must not exceed 15
Figure 13.
Figure 11 - Choke-On Anchor Installation
5.9 Cable Carabiner Anchor Installation: Ensure that the rated structural member is free of sharp, jagged, or abrasive edges.
1. Place the Cable Carabiner Sling Anchor over the top of the structural member with the carabiner hanging on one side and the two
D-rings hanging on the other, see Figure 14. Connect the carabiner to one of the two D-rings, see Figure 15. The unattached D-ring
shall be used as the attachment point.
2. Ensure ensure that the Cable Carabiner Sling Anchor cannot come off of the structural member at any point along the intended path
of movement or at joints or ends.
3. If the structural member that this Cable Carabiner Sling Anchor is attached to is sloped or vertical, the anchor must be positioned
next to a stop which will prevent it from sliding or moving in the event of a fall. The load direction must not exceed 15
Figure 16.
Figure 14 - Choke-On Anchor Installation
MANC03 Rev B
Figure 12 - Installation
Figure 15 - Installation
040320
as shown in
o
Figure 13 - Load Direction
15 15
o o
as shown in
o
Figure 16 - Load Direction
15 15
o o
8