Status / Alarm Codes - Gtec Saturn Manual Del Usuario

S /
TATUS ALARM CODES
By using a sophisticated self-diagnostic system, this CPS can check and indicate on the display panel its status and any error
and/or fault occurred during operation. Whenever a problem arises, the CPS signals the event by showing the code and the
corresponding alarm on the display.
➢
Status: these codes indicate the current status of the CPS.
CODE
S01
S02
S03
S04
S05
S06
S07
S08
S09
S10
S11
S12
S13
➢
Commands: these codes indicate that a command has been activated.
CODE
C01
C02
C03
C04
C05
C06
C07
C08
➢
Warnings: these messages refer to a specific configuration or operation of the CPS.
CODE
W01
W02
W03
W04
W05
DESCRIPTION
Precharging
Load not powered (stand-by status)
Start-up phase
Load powered by bypass line
Load powered by inverter
Battery operation
Waiting for batteries to recharge
Economy mode enabled
Ready for start-up
CPS locked – load not powered
CPS locked – load on bypass
BOOST stage or battery-charger locked – load not powered
Frequency converter - load powered by inverter
DESCRIPTION
Remote switch-off command
Remote load on bypass command
Remote start-up command
Battery test running
Manual bypass command
Emergency switch-off command
Remote battery charger switch-off command
Load on bypass command
DESCRIPTION
Low battery warning
Programmed switch-off enabled
Programmed switch-off imminent
Bypass disabled
Synchronisation disabled (CPS in Free running mode)
110