Mains Start - Up - Gtec Saturn Manual Del Usuario

M -
AINS START UP
➢ Close the SWIN and SWBYP (if present) and leave the SWMB maintenance isolator open.
After a few moments the CPS will be activated. The condensers are pre-charged and the "Lock / stand-by" led will start to
flash: The CPS is in stand-by mode.

➢ Press the
confirm, press "YES" and then press the
LEDs on display will turn on for about a second and you should hear a beep. The start-up sequence ends when the CPS
enters the "load on inverter" status.
S
WITCHING OFF THE
From the main menu, select "OFF" and press
the option "YES – CONFIRM" and press
mode. With the CPS in stand-by, in order to shut down the CPS completely, open the input disconnector SWIN and bypass
disconnector SWBYP.
Note: during prolonged periods of inactivity it is advisable to shut down the CPS by opening all disconnectors. Lastly,
with the CPS off, open the battery fuse holders.

CPS


button to access the start-up menu. When requested to
89
button again to confirm. All
the submenu. Then select
. The CPS will enter "stand-by"