Communication Ports - Gtec Saturn Manual Del Usuario

C
OMMUNICATION PORTS
In the upper part of the CPS, behind the door (see "Views of the CPS") there are the following communication ports:
➢
Serial port, available with RS232 connector and USB connector.
NOTE: the choice of one connector automatically excludes the other.
➢
Expansion slots for additional COMMUNICATION SLOT interface boards
➢ Expansion slot for power relay boards (see section "MultiCOM 392 board")
RS232 USB
AND CONNECTORS
RS232 CONNECTOR
PIN # NAME TYPE
1
2 TX OUT
3 RX
4
5 GND POWER
6 OUT
7
8 +15V POWER
9 WKATX OUT
C S
OMMUNICATION LOT
This CPS is equipped with two expansion slots for accessory communication boards (MultiCOM 392), which allow the device to
communicate using the main communication standards (see the "Front views of the CPS" paragraph).
Here are some examples:
➢
Second RS232 port
➢
Serial duplicator
➢
Ethernet agent with TCP/IP, HTTP and SNMP protocol
➢
RS232 + RS485 port with JBUS / MODBUS protocol
For further information on the accessories available, please visit the website.
SIGNAL
IN
TX serial line
IN RX serial line
Isolated power supply
15V±5% 80mA max
ATX power supply wake-up
PIN #
1
2
3
4
98
USB CONNECTOR
4 3
1 2
SIGNAL
VBUS
D-
D+
GND