Before First Use; The Salt Container - AEG FFB52600ZW Manual De Instrucciones

Not all options are
compatible with each other.
If you have selected non
compatible options, the
appliance will automatically
deactivate one or more of
them. Only the indicators of
the options still active will
stay on.
7.1 XtraDry
Activate this option to boost the drying
performance. With XtraDry on, the
duration of some programmes, water
consumption and the last rinse
temperature can be affected.
XtraDry is a permanent option for all
programmes other than
need not to be selected at every cycle.
In the other programmes the setting of
XtraDry is permanent and it is
automatically used in next cycles. This
configuration can be changed at any
time.
Every time
activated, XtraDry is off and
needs to be chosen
manually.
Activating XtraDry deactivates TimeSaver
and vice versa.

8. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
After starting a programme, it may take
up to 5 minutes for the appliance to
recharge the resin in the water softener.
It seems that the appliance is not
How to activate XtraDry
Press Option until the indicator
comes on.
If the option is not applicable to the
programme, the related indicator does
not come on or it flashes quickly for a
few seconds and then goes off.
The display shows the updated
programme duration.
7.2 TimeSaver
This option increases the pressure and
the temperature of the water. The
washing and the drying phases are
shorter.
The total programme duration decreases
by approximately 50%.
and
The washing results are the same as with
the normal programme duration. The
drying results can decrease.
How to activate TimeSaver
Press Option until the indicator
comes on.
is
If the option is not applicable to the
programme, the related indicator does
not come on or it flashes quickly for a
few seconds and then goes off.
The display shows the updated
programme duration.
working. The washing phase starts only
after this procedure is completed. The
procedure is repeated periodically.

8.1 The salt container

The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
ENGLISH 33