Connecting The Vs-2 To Your Media Center - Bose LIFESTYLE VS-2 Guía De Usario

00_LasikOG.book Page 6 Thursday, October 26, 2006 1:23 PM

Connecting the VS-2 to Your Media Center

Preparation
When setting up a LIFESTYLE ® system with the VS-2, the media center
power supply plugs into the VS-2 instead of the media center.
• If you are setting up the VS-2 and your LIFESTYLE
same time, find the media center power supply in the LIFESTYLE
system carton before you begin.
• If you are adding the VS-2 to an existing LIFESTYLE
off your LIFESTYLE system, wait 30 seconds, and unplug the media
center power supply from the wall outlet. Then, disconnect the power
supply from the rear panel of the media center. Also, remove any video
cables from the Video OUT and Video IN connectors on the media center.
Connecting the VS-2 to your media center
• Connect the 4-connector end of the VS-2 cable to your media center:
1 Insert the Serial Data plug into the Serial Data connector.
2 Insert the DC Power plug into the DC Power connector.
3 Insert the Composite plug into the Composite Video OUT connector.
4 Insert the S-Video plug into the S-Video OUT connector.
• Connect the other end of the VS-2 cable to the VS-2 end panel:
5 Insert multi-pin plug into the Media Center connector.
6 Insert the DC Power plug into the DC POWER Out connector.
• Connect the media center power supply to the end panel of the VS-2:
7 Insert the DC power cable from the media center power supply into the
DC POWER In connector.
Note: Straighten the DC power cord from the media center power supply and
from the VS-2 to the media center as much as possible. This cord is used as
the antenna for your LIFESTYLE ® system remote control.
6
® system at the
® system, turn
1 2
VS-2 cable
WARNING:
that came with your LIFESTYLE
Media center rear panel
Media center power supply
3 4
VS-2 end panel
7
6
The VS-2 must be used only with the media center power supply
® DVD home entertainment system.
English
5