Operating Your Dryer - LG RV1329CN7P El Manual Del Propietario

14

OPERATING YOUR DRYER

OPERATING YOUR DRYER
1. Ready mode
1) Coin / Card type
- The cycle LEDs flash at the same time, when the
price of cycles are equal.
2) OPL type
- The cycle LEDs is lit at the same time, and displayed
'PUSH' .
NOTE
• Price setting varies by country.
• Set your country from
(Refer How to enter the
• After EEPT, reset your country.
(Default country is KOR)
2. Insert card/coin (not for OPL type)
Insert a cash card that has a sufficient balance.
The card balance should be more than the
programmed vend price for a selected cycle.
NOTE
When the card balance is not enough, machine
displays the balance for 5 seconds and then displays
message repetitively
Insert a sufficient amount of change that is a more
than the programmed vend price for a selected cycle.
NOTE
When the coin amount is not enough, the machine
will not start.
3. Select the cycle
Press the desired cycle and the start button. The display
LED will show the remaining time and the selected cycle
starts.
NOTE
The last 2 minutes of the remaining time are always
for the cool down portion.
mode.
)
4. Top off (To add more time)
After a debit card is inserted, the operating time can
be increased to 20 minutes / 500, when the
Start button or the chosen course button has been
pressed.
(The card should have enough balance to satisfy
increasing time.)
The operating time can be increased to 20 minutes /
500 (default) by adding more coins.
NOTE
Owner can control the additional time and money
setting (top off price).
When the COOL DOWN has been working, if time is
added, it goes back to the Dry.
Time can be added up 99 minutes.
5. Change cycle
You cannot change the cycle while the machine is
running.
But if the door is opened, the machine stops
temporarily and the cycle can be changed.
Press the Pause button then you can change the
cycle.
6. Cycle finish
After the COOL DOWN of cycle, the machine stops
and LED display shows End.
If you press any key or open the door, the dryer
defaults to the ready mode.