Electrical Connection - GE Profile HGE6030DI Manual De Uso

Electrical
Connection
Conecction of
the Feeding
Cable to the
Mains
24
The appliances are provided with a three-pole feeding cable and
work with alternate current and single-phase voltage indicated on
the "Rating plate of the product "report at the end of the instruction
manual and on the product. The grounding conductor of the cable
is marked with the colours yellow/green.
Connect the feeding cable of
the oven to a plug suitable for
the load indicated on the rating
plate of the product. In case of
a direct connection to the mains
(cable without plug), it is neces-
sary to insert a suitable omnipo-
lar switch before the appliance,
with minimum opening between
contacts of 3 mm (the grounding
wire should not be interrupted
by the switch).
Before connecting to the mains,
make sure that:
• The electrical counter, the
safety valve, the feeding line
and the socket are adequate to
withstand the maximum load
required (see rating plate).
• The supply system is regular-
ly grounded, according to the
regulations in force.
• The socket or the omnipolar
switch can easily be reached
after the installation of the
oven
WARNING: If the feeding cable is damaged, it should be
replaced by the manufacturer or his service agency or
by qualified personnel to avoid any risks.
This appliance complies with Specification:
- 2006/95/CE
- 2004/108/CE
- 89/109/CE
- 2002/96/CE
• After carrying out the connec-
tion to the mains, check that the
supplying cable does not come
into contact with parts subject
to heating.
• Never use reductions, shunts,
adaptors which can cause
overheating or burning.
The manufacturer is not li-
able for any direct or indirect
damage caused by faulty in-
stallation or connection. It is
therefore necessary that all
installation
operations are carried out by
qualified personnel comply-
ing with the local and general
regulations in force.
(low voltage equipment)
(electromagnetic compatibility)
(components coming in contact with foodstuffs)
(WEEE)
and connection