GE Profile HGE6030DI Manual De Uso página 32

Control Lock
Faults
Energy Saving
Power Cut
Safety
Thermostat
Cooling Motor
3
The control lock is useful both to prevent children from switching
on the oven or prevent settings being changed while cleaning the
display.
It is engaged/disengaged by touching the symbol
seconds until the
If the display shows the message "ERR" and a buzzer sounds, it
means that there is a malfunction.
Please contact the technical assistance service.
The automatic energy saving system becomes active when the
programmed cooking period is more than one hour (both for
programming only the end of cooking time and at the start and end
of cooking ). This system switches off the heating elements a few
minutes earlier, without damaging the quality of the cooking and
thus saving energy.
The automatic activation of this function is shown on the display by
the message "Eco".
Following a power cut of about 0 minutes, the oven will resume its
functions normally. If the power cut is longer, when the power does
return, the display goes back to standby with the clock at zero. In
this case, you must reset the time, cooking function and cooking
programme.
It cuts out the electric supply for preventing possible overheatings
when the appliance is not correctly used. In this case, wait that the
oven cools down before using it again.
On the other hand, if a fault is present on the appliance's compo-
nents, we advise calling the Technical Assistance Service must be
contacted.
The oven is equipped with a cooling motor for the internal
components and the control panel. This device automatically comes
into operation when the temperature inside the oven exceeds a pre-
established value and remains on, after turning off the oven, until
said temperature is lowered.
symbol appears on the display.
for a few