Electrolux EXM18HV1W Manual De Instalación página 18

2 The yellow-green wire in air conditioner is
2 The yellow-green wire in air conditioner is
the earthing wire which can not be used for
the earthing wire which can not be used for
other purposes. Improper earthing may cause
other purposes. Improper earthing may cause
electric shock.
electric shock.
3 The earth resistance should accord to the
3 The earth resistance should accord to the
national wiring regulation.
national wiring regulation.
4 The user's power must have reliable earthing
4 The user's power must have reliable earthing
terminal. Do not connect the earthing wire with
terminal. Do not connect the earthing wire with
the following:
the following:
• Water pipe
• Water pipe
• Gas pipe
• Gas pipe
• Contamination pipe
• Contamination pipe
installation of indoor
Installation of Indoor
Electric Wires
Electric Wires
1 Open the front panel and remove the wiring
1 Open the front panel and remove the wiring
cover by loosening the screw.
cover by loosening the screw.
2 Route the power connection cable and signal
2 Route the power connection cable and signal
control wire (for heap pump model only) from
control wire (for heap pump model only) from
back of the indoor unit and pull it toward the
back of the indoor unit and pull it toward the
front through the wiring hole for connection.
front through the wiring hole for connection.
3 Connect and screw the wires onto the
3 Connect and screw the wires onto the
terminal block as identified by their colors.
terminal block as identified by their colors.
4 Wrap wires that are not connected with
insulating tape so that they do not touch any
electrical or metal parts.
5 Secure the wires firmly with the cable clamp.
6 Put the wiring cover back and screw it.
7 Reinstall the front panel.
18
17
Wiring cover
Wiring cover
EXM09HV1Wi
2640~5275W, Heat Pump models
EXM12HV1Wi
Heat Pump models
Wiring Cover
Wiring Cover
6450W, Heat Pump models
caution
All wires between indoor and outdoor units
Wiring Cover
must be connected by a qualified electric
contractor.
• If the length of the power cord is not
enough, please contact your supplier for
new power cord. Lengthen the power cord
by yourself is not allowed.
caution
• After tightening the screws, pull the wire
4 Wrap wires that are not connected with
slightly to confirm whether it's firm or not.
insulating tape so that they do not touch any
• Do not connect two power cables
electrical or metal parts.
together to supply power to the air
5 Secure the wires firmly with the cable
conditioner.
clamp.
• Do not extend the power cable conductor
6 Put the wiring cover back and screw it.
by cutting.
7 Reinstall the front panel.
caution
All wires between indoor and outdoor units
must be connected by a qualified electric
contractor.
• If the length of the power cord is not
enough, please contact your supplier for
new power cord. Lengthen the power cord
by yourself is not allowed.
2 3
N(1)
yellow-
blue black yellow-
blue black brown
brown
green
green
outdoor unit connection
2 3
N(1)
yellow-
blue black brown
green
outdoor unit connection