Toring Aedial Umber; Inserting A Pause In The Dialing Sequence; Reviewing, Changing Or Deleting Stored Names/Numbers - GE 25880 Guia Del Usuario

Storing a Redial Number
1. Make sure the phone is OFF (not inTALK mode).
2. Repeat step 1 through 6 in Storing a Name and Number in Memory.
3. Press redial to display the redial number and name.
4. Press memory/conference again to confirm.
NOTE : If the number you want to redial has more than 24 digits, the
telephone number cannot be stored in memory.

Inserting a Pause in the Dialing Sequence

Press the #pause button on the touch-tone pad twice to insert a delay in the
dialing sequence of a stored telephone number when a pause is needed to
wait for a dial tone (for example, after you dial 9 for an outside line, or wait for
a computer access tone.) Each pause counts as 1 digit in the dialing sequence.

Reviewing, Changing or Deleting Stored Names/Numbers

To Review: Press memory/conference on the handset or on base, then press
the caller ID (rev or skip) button (on base) or the caller ID/vol (- or +) button
(on cordless handset) to scroll through the stored numbers. Or press the
memory location number.
To Change: Follow the steps under Storing a Name and Number in Memory
except replace the stored name or number with the new information.
To Delete: Press memory/conference on the handset or on base, then press
the caller ID (rev or skip) button (on base) or the caller ID/vol (- or +) button
(on cordless handset) to scroll to a desired memory.
1. While the entry displays, press delete button on base or del/chan button
on handset to mark the entry for deletion.The display shows DELETE?
2. Press delete button on base or del/chan button on handset again to
delete the entry. **DELETED** is displayed.
27