Connecting The Telephone Line; Connecting The Corded Handset; Wall Mounting The Base - GE 25880 Guia Del Usuario

Connecting the Telephone Line

On the base, plug one end of the straight telephone line cord into the jack on
the back of the base and the other end into a modular wall telephone jack.

Connecting the Corded Handset

1. Connect one end of the coiled handset cord to the jack on the side of the
base.
2. Connect the other end of the coiled cord to the jack on the handset, then
place the handset in the base cradle.

Wall Mounting the Base

The base is packaged with the pedestal attached in desktop mode.To
mount the base on the wall:
1. Turn the base over and remove the pedestal.
2. Rotate the pedestal a half turn, and align it with the bottom of the base.
3. Attach the pedestal by first inserting the tabs on the pedestal into the
slots on the bottom of the base, and then push the pedestal down until it
snaps into place.
4. Plug the telephone line cord into the jack marked PHONE LINE on the
back of the base and the other end into a modular phone jack.
5. Feed the telephone line cord and power adaptor cord through the
grooves on the pedestal to allow the unit to rest flat against the wall.
6. Slip the mounting holes on the pedestal over the wall plate posts and
firmly slide the unit into place. (Wall plate not included.)
7. Remove the handset hook, turn it upside down, and put it back in the slot.
You need to do this so the corded handset doesn't fall out of the base.
8. Place the corded handset in the base cradle.
NOTE: If desired, gather the extra telephone line and power adaptor cord
together, fasten with a wire tie.
12