Checking The Battery Charge Level; Attaching The Auxiliary Handle; Changing Tools; Selecting Torque/Operating Mode - Parkside PSBSA 18-Li B2 Traducción Del Manual De Instrucciones Original

Removing the battery pack:
♦ Press the release button
battery pack.

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
♦ RED/ORANGE/GREEN = maximum charge/
power
RED/ORANGE = medium charge/power
RED = low charge – charge the battery

Attaching the auxiliary handle

♦ Screw the additional handle
hand or the right-hand side of your appliance
depending on the way you work.

Changing tools

Your cordless combi drill has a fully automatic
spindle lock .
When the motor is stopped, the power train is
locked so that the chuck
ing . After you have attached the desired tool
and tightened it by turning the chuck
continue working. The spindle lock is automatically
released when the motor starts (ON/OFF switch
pressed ).

Selecting torque/operating mode

The torque selector allows adjustment of the torque
or selection between the drill setting and the
hammer drill setting .
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard materials
or removing screws.
♦ Select the drill setting for drilling work by adjust-
ing the torque selection ring to the position .
♦ Select the hammer drill setting for hammer drilling
work by adjusting the torque selection ring to
the position .
PSBSA 18-Li B2
and remove the
to
as follows:
onto the left-
can be opened by turn-
, you can

2 speed gearbox

CAUTION!
► Only operate the speed selection switch
when the appliance is at a standstill.
Otherwise the appliance can be damaged.
In first gear (speed selector switch
position: 1)
you can reach a speed of approx. 440 rpm and
a high torque. This setting is suitable for all screw-
driving but also for the use of accessories.
In second gear (speed selector switch
position: 2)
you can reach a speed of approx. 1650 rpm for
carrying out drilling work.

First use

Switching on and off
Switching on:
♦ To start the appliance, press and hold the ON/
OFF switch .
The LED work light
ON/OFF switch
♦ This allows illumination of the work area in low
light conditions.
Switching off:
♦ Release the appliance's ON/OFF switch
switch off the appliance.

Setting the rotational speed

Pressing the ON/OFF switch
low rotational speed. Increasing pressure increases
the speed.
NOTE
► The integrated motor brake ensures a quick
stop.

Changing the direction of rotation

♦ Change the direction of rotation by pressing the
rotational direction switch
or right.
in
in
illuminates when the
is depressed even lightly.
lightly provides a
towards the left
GB
MT
to
43