5
INSTALLATION
The installation procedure below only applies if the TM-CU vehicle configuration has been
installed as described in the Vehicle Configuration Installation Handbook (see Section 1.3,
Document [1]).
Note:
Dashboard installation is strongly recommended. The pivot on the TM-CU shell
reduces the system's mechanical performance (resistance to rotation).
5.1
INSTALLATION DIAGRAMS
5.1.1
TM-CU installation in the new vehicle configuration (full installation)
External accessory
TM-CU
System cable
HG5621
Figure 5.1
TM-CU INSTALLATION DIAGRAM (NEW VEHICLE CONFIGURATION)
This document and its contents are the property of Airbus DS SLC and must not be copied or circulated without authorisation.
Any usage outside the subject expressly specified is prohibited. Copyright
IH - PS11760AQLAB01
TETRAPOL Mobile - Control Unit - Hardware Installation Handbook
Voice accessory
BER
External LSs
Antenna
©
2015 - 2019 - Airbus DS SLC - All rights reserved.
08/2019
UDT
9/19
E
N
G
L
I
S
H