Tm-Cu Din Car Mounting Kit; Installing The Din Rack Securing Kit; Connecting The Tm-Cu - Airbus TETRAPOL MOBILE Instrucción De Instalación

TETRAPOL Mobile - Control Unit - Hardware Installation Handbook
5.3

TM-CU DIN CAR MOUNTING KIT

E
5.3.1

Installing the DIN rack securing kit

N
• Position the two DIN brackets (item 5) on the TM-CU (item 2)
G
• Hold the two DIN brackets in place (item 5) with the O-rings (item 13), two fastening
L
screws (item 12) and NYLSTOP nuts (item 6)
I
5.3.2

Connecting the TM-CU

S
• On the back panel of the TM-CU:
H
- Connect the voice accessory cable connector (item 12) to the 16-point male
connector
- Insert the voice accessory cable into its recess in the back panel of the TM-CU
(item 13)
- Insert the first rubber retaining piece into its recess in the back panel of the TM-CU
(item 14)
Note:
- Insert the second rubber retaining piece (item 8) into the bracket of the TM-CU
(item 7)
- Pass the voice accessory cable through the slot (item 6) in the front face of the
TM-CU
- If used, connect the external accessory cable connector (item 3) to the 24-point audio
accessory male connector
- Insert the external accessory cable into its recess (item 4)
- Insert the rubber retaining piece into its recess (item 5)
Note:
1st case: no existing configuration (system cable HG5621)
• If necessary, install the seal for Sub-D 25-pin connector (Plate A-V, item 2) on the 25-pin
connector for system cable HG5621 to ensure a IP54 level seal
• Connect the system cable to the BER
• On the back panel of the TM-CU (Plate A-IV):
- Connect the system cable HIROSE connector (item 11) to the 22-pin male system
connector linking it to the terminal
- Insert the system cable into its recess (item 10)
- Insert the rubber retaining piece into its recess (item 9)
This document and its contents are the property of Airbus DS SLC and must not be copied or circulated without authorisation.
Any usage outside the subject expressly specified is prohibited. Copyright
14/19
(Plate A-IV)
As the cable is not centred in the rubber retaining piece, position the rubber
retaining piece inside its recess so that the voice accessory cable is towards
the outside.
As the 4-point male USB socket (item 2) is not being used, the sealing plug
must not be removed.
(Plate A-II)
©
2015 - 2019 - Airbus DS SLC - All rights reserved.
08/2019
IH - PS11760AQLAB01