Installing The Tm-Cu Desktop Kit; Connecting The Tm-Cu - Airbus TETRAPOL MOBILE Instrucción De Instalación

TETRAPOL Mobile - Control Unit - Hardware Installation Handbook
5.4

INSTALLING THE TM-CU DESKTOP KIT

E
5.4.1 Installing the TM-CU desktop kit
N
• Secure the pivot support (item 11) on the desktop disk (item 18) with the three fastening
G screws (item 10)
L
• Secure the pivot (item 8) on the shell (item 3) with the fastening screw (item 6)
I
• Position and secure the pivot (item 8) with the shell (item 3) on the pivot support
(item 11) with the fastening screw (item 9)
S
• Place the non-slip foam (item 17) on the desktop, then place the disk assembly
H
(item 18) on the non-slip foam
• Thread the various connectors of the system cables, voice accessories and
loudspeaker through the openings in the back of the dashboard shell
5.4.2

Connecting the TM-CU

• On the back panel of the TM-CU:
- Connect the voice accessory cable connector (item 12) to the 16-point male
connector
- Connect the HIROSE connector (DF series, 11-22-pin female connector) of the
adapter cable HG5620 (item 11) to the 22-pin male system connector of the TM-CU
- Insert the adapter cable into its recess (item 10)
- Insert the rubber retaining piece into its recess (item 9)
- Insert the voice accessory cable into its recess in the back panel of the TM-CU
(item 13)
- Insert the first rubber retaining piece into its recess in the back panel of the TM-CU
(item 14)
Note:
- Insert the second rubber retaining piece (item 8) into the bracket of the TM-CU
(item 7)
- Pass the voice accessory cable through the slot (item 6) in the front face of the
TM-CU
- If used, connect the external accessory cable connector (item 3) to the 24-point audio
accessory male connector
- Insert the external accessory cable into its recess (item 4)
- Insert the rubber retaining piece into its recess (item 5)
Note:
• Connect the Sub-D 25-pin male connector of the adapter cable HG5620 to the Sub-D
25-pin female connector of the system cable HG4469 in place
This document and its contents are the property of Airbus DS SLC and must not be copied or circulated without authorisation.
Any usage outside the subject expressly specified is prohibited. Copyright
16/19
(Plate A-IV)
As the cable is not centred in the rubber retaining piece, position the rubber
retaining piece inside its recess so that the voice accessory cable is towards
the outside.
As the 4-point male USB socket (item 2) is not being used, the sealing plug
must not be removed.
(Plate A-III)
©
2015 - 2019 - Airbus DS SLC - All rights reserved.
08/2019
IH - PS11760AQLAB01