Installing The Tm-Cu In The Car Radio Compartment - Airbus TETRAPOL MOBILE Instrucción De Instalación

2nd case: with a CCP configuration (system cable HG4354)
• Connect the Sub-D 25-pin male connector of the adapter cable HG5619 to the Sub-D
25-pin female connector of the system cable HG4354 in place
• On the back panel of the TM-CU:
- Connect the HIROSE (DF series, 11-22-pin female connector) connector of the
adapter cable (item 11) to the 22-pin male system connector of the TM-CU
- Insert the adapter cable into its recess (item 10)
- Insert the rubber retaining piece into its recess (item 9)
3rd case: with a CH configuration (system cable HG5114)
• Connect the Sub-D 25-pin male connector of the adapter cable HG5620 to the Sub-D
25-pin female connector of the system cable HG5114 in place
• On the back panel of the TM-CU:
- Connect the HIROSE (DF series, 11-22-pin female connector) connector of the
adapter cable (item 11) to the 22-pin male system connector of the TM-CU
- Insert the adapter cable into its recess (item 10)
- Insert the rubber retaining piece into its recess (item 9)
5.3.3

Installing the TM-CU in the car radio compartment

• Install and secure the cable support plate (item 4) to the back panel of the TM-CU with
two butterfly screws (item 3)
• Carefully insert the TM-CU assembly (item 2) in the car radio compartment
• Tighten the two fastening screws (item 12) to secure the TM-CU (item 2) in the
compartment
This document and its contents are the property of Airbus DS SLC and must not be copied or circulated without authorisation.
Any usage outside the subject expressly specified is prohibited. Copyright
IH - PS11760AQLAB01
TETRAPOL Mobile - Control Unit - Hardware Installation Handbook
(Plate A-II)
©
2015 - 2019 - Airbus DS SLC - All rights reserved.
08/2019
E
N
G
L
I
S
H
15/19