Installing The Tm-Cu In The Car Radio Compartment - Airbus TETRAPOL MOBILE Instrucción De Instalación

5.4.3

Installing the TM-CU in the car radio compartment

• Install and secure the cable support plate (item 5) to the back panel of the TM-CU with
two butterfly screws (item 4)
• Install the dashboard seal (item 7) on the dashboard shell (item 3), paying attention to
the order of assembly. The seal tab labelled "L" (Left) must be positioned on the left.
• Carefully insert the TM-CU assembly (item 2) in the dashboard shell (item 3)
• Secure the TM-CU (item 2) in the dashboard shell (item 3) with two fastening screws
(item 20)
5.5 INSTALLING THE LOUDSPEAKER (OPTIONAL)
• Secure the MOLEX 2-pin male connector supplied with the system cable to the
loudspeaker cable (item 11):
- Cut any connectors on the loudspeaker cable (items 10 and 12)
- Strip both ends of the loudspeaker cable (items 10 and 12)
- Crimp both contacts (item 9) on the MOLEX connector
- Insert both contacts (item 9) into the connector (item 8), in compliance with the
polarity given on Plate A-V
1st case: installing the loudspeaker without existing vehicle configuration
• Connect the loudspeaker cable connector to the 2-pin connector of the system cable
HG5621 (item 2)
2nd case: installing the loudspeaker with vehicle configuration for the CCP
• Connect the loudspeaker cable connector to the 2-pin connector of the system cable
HG4354
3rd case: installing the loudspeaker with vehicle configuration for the CH
• Connect the loudspeaker cable connector to the 2-pin connector of the adapter cable
HG5620 (item 6)
This document and its contents are the property of Airbus DS SLC and must not be copied or circulated without authorisation.
Any usage outside the subject expressly specified is prohibited. Copyright
IH - PS11760AQLAB01
TETRAPOL Mobile - Control Unit - Hardware Installation Handbook
(Plate A-III)
©
2015 - 2019 - Airbus DS SLC - All rights reserved.
08/2019
(Plate A-V)
17/19
E
N
G
L
I
S
H