Kohler Vanity K-2435 Manual De Instrucciones página 10

Drawer – K-2435 (cont.)
Verify the drawer is properly engaged by lightly lifting each side
of the drawer upward. The drawer should stay in place on the
rails.
If the drawer lifts up, fully lift the drawer up off the rails of the
vanity. Repeat the "Reinstall" procedure OR follow the
"Alternative Method."
Alternative Method: Align and rest the rails of the drawer on the
rails of the vanity. Partially close the drawer, then pull the rails of
the vanity into the rails of the drawer. The rails will "snap" into
place.
Fully extend the drawer.
Reconnect the electrical track to the vanity, then secure with the
two screws.
Route the plug end of the electrical cord through the access hole
in the bottom of the vanity.
Secure the electrical cord with the cable clips.
Slide the drawer in and out to confirm proper operation.
Plug the electrical cord into the electrical outlet.
1059700-5-B 10 Kohler Co.