Kohler Vanity K-2435 Manual De Instrucciones página 9

1
2a
Drawer – K-2435
Remove
Unplug the electrical cord from the electrical outlet, if applicable.
Slide the drawer out on the rails until fully extended. (1)
Remove the electrical cord from the cable clips and pull the plug
end up through the access hole in the bottom of the vanity. (2a)
Disconnect the electrical track from the vanity by removing the
two screws holding the track in place. Retain the screws. (2c)
Pinch the release latches on each rail (2b) while pulling the
drawer away from the vanity. (3)
Reinstall
Slide the rails of the vanity out until fully extended.
Align and rest the rails of the drawer on the rails of the vanity.
Route the electrical cord through the drawer compartment.
With the rails still aligned, gently push the drawer into the vanity
until the rails "snap" into place.
Kohler Co.
2
2c
3
Disconnect track.
9
2b
1059700-5-B