Kohler Vanity K-2435 Manual De Instrucciones página 12

Drawer – K-2436, K-2437 (cont.)
Rest the drawer on top of the rails, then properly route the
electrical cord into the drawer compartment.
Hold the drawer in place with one hand and secure the electrical
track to the track clip.
Route the plug end of the electrical cord through the access hole
in the bottom of the vanity.
Secure the electrical cord with the cable clips.
Align and rest the drawer on the rails of the vanity.
Hold the drawer in place with one hand and pull the tab on the
bottom front of one rail toward you with the other hand. The rail
will "snap" into place.
Pull the tab on the bottom front of the other rail toward you. The
rail will "snap" into place.
Ensure the drawer is properly engaged by lightly lifting each side
of the drawer upward. The drawer should stay in place on the
rails.
If the drawer lifts up, fully lift the drawer up off the rails of the
vanity. Slide the rails of the vanity out until fully extended.
Repeat the "Reinstall" procedure above.
Slide the drawer in and out to confirm proper operation.
Plug the electrical cord into the electrical outlet.
Adjust
Slide the drawer out on the rails until fully extended. (1)
Turn the drawer height adjustment wheels to adjust the drawer
height. To lower the drawer, turn the wheel on the left side of the
drawer clockwise and/or the wheel on the right side of the
drawer counterclockwise. Turn the wheel(s) in the opposite
direction to raise the drawer. (2)
1059700-5-B 12 Kohler Co.