Lcd Menu Explanations - Tripp-Lite SMART1524ET Manual Del Propietário

Operation

LCD Menu Explanations

1. STATUS: There are six UPS STATUS information screens that report detailed
information on UPS operating factors and current site power conditions.
First STATUS Screen (3 selections)
• S/N (UPS serial number)
• I/P-V (UPS input line voltage)
• I/P-F (UPS input line frequency, Hz)
Second STATUS Screen (4 selections)
• BAT V (UPS battery voltage)
• BAT T (UPS battery sensor temperature)
• O/P-V (UPS output voltage)
• O/P-F (UPS output frequency, Hz)
Third STATUS Screen (4 selections)
• O/P-P...VA (UPS output load in VA)
• O/P-P...W (UPS output load in watts)
• LOAD (UPS output load percentage)
• RunTM (Runtime remaining)
Fourth STATUS Screen (4 selections)
• InvEV (Number of battery events since last reset)
• InvTM (Total hours on battery mode since last reset)
• BukEV (Number of times in BUCK mode since last reset)
• BukTM (Total hours in BUCK mode since last reset)
Fifth STATUS Screen (6 selections)
• BstEV (Number of times in BOOST mode since last reset)
• BstTM (Total hours in BOOST mode since last reset)
• C1 (Off-On status of C1 output contact)
• C2 (Off-On status of C2 output contact)
• C3 (Off-On status of C3 output contact)
• C4 (Off-On status of C4 output contact)
Sixth STATUS Screen (5 selections)
• C5 (Off-On status of C5 output contact)
• C6 (Off-On status of C6 output contact)
• MainFW (UPS firmware version)
• LCDFW (UPS LCD firmware version)
• HW (UPS hardware version)
19